Printer: Canon Laser Beam Printer LBP-810 Refill Toner Ink EP-22 Cartridge

Canon Laser Beam Printer LBP-810 Refill Toner Ink EP-22 Cartridge

Compatible with HP LaserJet 1100 and compatibles toner ink cartridges. Prints up to 2500 pages. 600 DPI. Black.

Cartridge:

  • EP-22 Cartridge

Compatible with:

  • Laser Shot LBP-1120
  • LBP-1110
  • LBP-1110 Premium
  • LPB-1110SE
  • LPB-1120
  • LPB-250
  • LPB-350
  • LPB-5585
  • LPB-800
  • LPB-810

The quality of the Canon LBP-810 is very good. It's a very old printer, without any chip.

Here is how you can refill this toner EP-22 Cartridge.

 

IMG_9050

 

The Result: As good as new

 

result.001

result.002

 

Step 1: Glue a hole (not drill!)

Do not drill, just glue a hole on top

I used an old simple solder iron.

Smooth the hole.

Make sure no parts get inside - if, remove it with tweezers.

 

IMG_9036

 

IMG_9039

 

IMG_9053

 

IMG_9040

 

Step 2: Refill

Just refill. I had an other old printer with lot of ink in it, so I just reused this ink.

IMG_9043

 

Step 3: Seal the hole

I just used reinforced tape. And I used a regular paper to cover the hole.

IMG_9046

 

IMG_9047

 

That's it! Just leave a comment below.

 

 

 

 

You can also use the original filling hole, but then you need to unscrew one side.

There are 2 (two) parts holding together with two pins and one screw.

Just make sure, that the pins don't fall in the containment inside the toner cartridge! Just push it in with a screwdriver of a smaller pin until you can loosen the other part. If you do it so, the pin will stay within the hole. Later on you can take them out, and reuse them.

IMG_9035

 

IMG_9032

 

IMG_9033

 

 

IMG_9031

 

Helpful?

Leave a Reply

Your email address will not be published. Required fields are marked *